S300i™e.One™SeriesTwo Channel Integrated Audio AmplifierBel Canto Design, LTD.212 Third Avenue NorthMinneapolis, MN 55401Phone: (612) 317.4550 Fax: (
Preamplifier Section:Bandwidth • DC-200KHzVolume setting for unity gain • 80.0Signal to Noise Ratio @ 2 Volt RMS • >95 dB A weighted, 20Hz-20kHz In
Bel Canto Design, LTD.212 Third Avenue NorthMinneapolis, MN 55401Phone: (612) 317.4550 Fax: (612) 359.9358 www.belcantodesign.com Info@belcantodesign
page 3© 2006 bel canto design, Ltd. S300i User’s Guide 0906 Rev. APlease take a moment to fill out your warranty regis-tration sheet. Returning this r
The power supply on the S300i is presetfor the proper power voltage. The powercable should have the correct plug foryour local power system. If you be
page 5© 2006 bel canto design, Ltd. S300i User’s Guide 0906 Rev. ABecause the S300i runs cool it can beplaced in many system locations withoutcompromi
page 6© 2006 bel canto design, Ltd. S300i User’s Guide 0906 Rev. AFront Panel Control Knob:The control knob is a continuously rotat-ing control with a
page 7© 2006 bel canto design, Ltd. S300i User’s Guide 0906 Rev. AMute: (available only on theremote)The S300i starts up in Soft Mute. Thislevel is 20
page 8© 2006 bel canto design, Ltd. S300i User’s Guide 0906 Rev. AVolume Up:Increases the output level in 0.5 Decibel (dB) steps over a range of 0.0 t
page 9© 2006 bel canto design, Ltd. S300i User’s Guide 0906 Rev. AS300i Rear PanelS300i Rear Panel ConnectionsNever Connect Either the Positive or Neg
Fuses and Protection CircuitryThere is an internal 1A (1 ampere) fastblow 5mmX20mm fuse for each amplifierboard. If any speaker output contacts thecha
Comments to this Manuals